TM 9-2320-366-34-2
Section II. MAINTENANCE PROCEDURES
3-2. DRESSED ENGINE UNPACKING/PACKING
This task covers:
a. Unpacking
b. Packing.
INITIAL SETUP
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque, 0-150 lb-in. (Item 91, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Sling, Multiple Leg (TM 9-2320-366-20)
Sling, Engine and Transmission, Motor Vehicle (Item
57, Appendix B)
Stand, Engine Transport (Item 69, Appendix B)
Wrench Set, Socket (Item 85, Appendix B)
Materials/Parts
Rag, Wiping (Item 60, Appendix C)
Tape, Duct (Item 86, Appendix C)
Desiccant (5) (Item 25, Appendix C)
Lockwasher (41) (Item 141, Appendix F)
Gasket (Item 58, Appendix F)
Personnel Required
(2)
a. Unpacking.
WARNING
Ensure all pressure is released from
engine container. Failure to comply may
result in injury to personnel.
(1) Depress and hold air release button (1) on engine
container breather valve (2) until all pressure is released.
WARNING
Engine
container
cover
weighs
approximately 130 lbs (59 kgs). Attach a
suitable lifting device prior to unpacking.
Failure to comply may result in injury to
personnel or damage to equipment.
(2) Remove 24 nuts (3), lockwashers (4), and screws (5)
from engine container cover (6). Discard lockwashers.
NOTE
Step (3) requires the aid of an assistant.
(3) Lift engine container cover (6) from engine container
base (7).
(4) Remove gasket (8) from engine container base (7).
Discard gasket.
3-2
