TM 9-2320-366-34-2
9-5. FRONT AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE YOKE
REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Puller Kit, Universal (Item 51, Appendix B)
Wrench Set, Socket, (Item 84, Appendix B)
Multiplier, Torque Wrench (Item 42, Appendix B)
Driver, Differential Pinion Seal (Item 51, Appendix D)
Driver, Front and Rear Differential Yoke Seal (Item
54, Appendix D)
Goggles, Industrial (Item 28, Appendix B)
Socket Set, Impact (Item 58, Appendix B)
Hammer, Hand, Soft Head (Item 33, Appendix B)
Tools and Special Tools (Cont)
Hammer, Soft Head (Item 33, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix
B)
Sling, Cargo (Item 56, Appendix B)
Holding Bar, Pinion (TM 9-2320-366-20)
Materials/Parts
Grease, Automotive and Artillery (Item 35,
Appendix C)
Seal, Plain Encased (Item 386.1, Appendix F)
Nut, Self-Locking (Item 193, Appendix F)
Screw, Cap (4) (Item 366.1, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
(1) Remove four screws (1) and two bearing cups (2) from
drive yoke (3). Discard screws.
(2) Slide drive shaft (4) from side to side and separate
universal joint (5) from drive yoke (3).
Change 1
9-19
