TM 9-2320-366-34-2
8-4. M1086/M1089 INTERMEDIATE FRONT DRIVE SHAFT AND COUPLER BEARING
REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Assembly
d. Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B)
Press, Arbor, Hand Operated (Item 48, Appendix B)
Hammer, Hand, Soft Head (Item 33, Appendix B)
Rag, Wiping (Item 60, Appendix C)
Materials/Parts
Grease, Automotive and Artillery (GAA) (Item 35,
Appendix C)
Nut, Self-Locking (2) (Item 204, Appendix F)
Screw, Cap (12) (Item 366.1, Appendix F)
Nut, Self-Locking (Item 196.1, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the possibility
of falling debris. Failure to comply may
result in injury to personnel.
a. Removal.
(1) Remove four screws (1) and two bearing cups (2) from
intermediate front drive yoke (3). Discard screws.
(2) Slide intermediate front drive shaft (4) from side to side
and separate universal joint (5) from intermediate front
drive yoke (3).
Change 1
8-11
