TM 9-2320-366-34-2
(8) Install preformed packing (13) on 90-degree fitting (14).
(9) Install 90-degree fitting (14) on fuel governor (4).
(10) Install check valve (15) in fuel governor (4).
(11) Install preformed packings (16 and 17) on adapter (18).
(12) Install adapter (18) in fuel governor (4).
(13) Install 90-degree fitting (19) on adapter (18).
(14) Install gasket (20) on fuel governor (4).
d. Installation.
(1) Position fuel governor (1) on engine (2) with three
washers (3) and bolts (4).
(2) Tighten three bolts (4) to 15-25 lb-ft (20-34 N·m).
(3) Install preformed packing (5) on adapter sleeve (6).
WARNING
Use care when installing retaining clips.
Retaining clips are under tension and can
act as projectiles when released. Failure to
comply may result in injury to personnel.
(4) Install clevis pin (7) and retaining clip (8) in fuel governor
clevis (9).
4-43
