TM 9-2320-366-34-2
4-9. FUEL GOVERNOR REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Assembly
d. Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Cab raised (TM 9-2320-366-10-).
Fuel shutoff solenoid removed (para 6-4).
Fuel ratio control tube removed (TM 9-2320-
366-20-3).
Governor linkage removed (TM 9-2320-366-20-
3).
Fuel setting checks performed (para 4-4).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Tool Kit, Auto Fuel and Electrical System
Repair (Item 75, Appendix B)
Wrench, Torque, 0-200 lb-in. (Item 93,
Appendix B)
Wrench Set, Socket (Item 85, Appendix B)
Tools and Special Tools (Cont)
Pliers, Slip Joint (Item 47, Appendix B)
Pan, Drain (Item 43, Appendix B)
Materials/Parts
Packing, Preformed (2) (Item 255, Appendix F)
Packing, Preformed (2) (Item 240, Appendix F)
Parts Kit, Engine Fuel Pump (Item 312, Appendix F)
Packing, Preformed (2) (Item 248, Appendix F)
Packing, Preformed (Item 257, Appendix F)
Gasket (Item 44, Appendix F)
Packing, Preformed (Item 268, Appendix F)
Packing, Preformed (2) (Item 249, Appendix F)
Personnel Required
(2)
a. Removal.
(1) Position drain pan under radiator draincock (1).
(2) Drain radiator (2) about halfway [approximately 15-20 qt
(14-19 L)].
(3) Disconnect fuel hose (3) from 90-degree fitting (4).
(4) Loosen hose clamp (5) on coolant hose (6).
(5) Disconnect coolant hose (6) from coolant tube
(7).
4-37
