TM 9-2320-366-34-2
3-22. INLET MANIFOLD REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Valve cover removed (TM 9-2320-366-20-3).
Air inlet elbow removed (para 3-20).
Inlet manifold cover removed (para 3-21).
Fuel ratio control tube removed (TM 9-2320-366-
20-3).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque, 0-150 lb-in. (Item 91, Appendix B)
Tools and Special Tools (Cont)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Socket, Socket Wrench (Item 63, Appendix B)
Wrench Set, Socket (Item 85, Appendix B)
Materials/Parts
Packing, Preformed (2) (Item 242, Appendix F)
Packing, Preformed (Item 249, Appendix F)
Gasket (Item 35, Appendix F)
Sealing Compound (Item 71, Appendix C)
a. Removal.
(1) Disconnect two ether start tubes (1) from ether start
nozzles (2).
(2) Remove two ether start nozzles (2) from adapters (3).
(3) Remove two adapters (3) from inlet manifold (4).
(4) Remove two preformed packings (5) from adapters (3).
Discard preformed packings.
(5) Remove fitting (6) from inlet manifold (4).
(6) Remove preformed packing (7) from fitting (6). Discard
preformed packing.
3-128
