INITIAL SETUP   Equipment Condition     Engine shut down (TM 9-2320-366-10-1).     Batteries disconnected (TM 9-2320-366-20-3).   Tools and Special Tools     Tool Kit, Genl Mech (Item 78, Appendix B)     STE/ICE-R (Item 70, Appendix B)     Multimeter, Digital (Item 41, Appendix B)     Goggles, Industrial (Item 28, Appendix B)     Pan, Drain (Item 43, Appendix B)     Wrench, Torque, 0-200 lb-in. (Item 93, Appendix B)     Wrench Set, Socket (Item 85, Appendix B) Materials/Parts   Gasket (Item 68, Appendix F)   Oil, Lubricating (Item 46, Appendix C)   Wire, Elect, 50 ft (Item 97, Appendix C) Personnel Required     (2) References     TM 9-4910-571-12&P TM 9-2320-366-34-1 2-616          Change 1             KNOWN INFO                         TEST OPTIONS            Continuity Test or STE/ICE-R Test #91     REASON FOR QUESTION     Replace transmission external wiring harness (para 6-7). WARNING       CAUTION       Read WARNING and CAUTION on following page. START YES 1. NO        POSSIBLE PROBLEMS        Circuit breaker OK. Batteries OK. WTEC III cab transmission harness OK. Faulty transmission external wiring harness. Faulty output speed sensor. Faulty transfer case wiring harness. Faulty WTEC III transmission ECU. Is continuity present from connector P119-n to connector P71-C? If continuity is not present, transmission external wiring harness is faulty. c50. WTEC III TRANSMISSION PUSHBUTTON SHIFT SELECTOR (TPSS) DISPLAYS MAIN CODE         22 SUB CODE 16