TM 9-2320-366-34-1Change 1 2-257CONTINUITY TESTCAUTIONNOTEUse care when testing electrical connectors.Do not damage connector pins or socketswith multimeter probes. Failure to complymay result in damage to equipment.Inspect connector pins/sockets for damage,corrosion, and serviceability. Check thatconnector pins are not pushed back andare capable of making good contact.(1) Set multimeter to ohms.(2) Connect positive (+) probe of multimeterto connector P119-V.(3) Connect negative (-) probe of multimeter toexternal wiring harness 31-pin connectorpin L and note reading on multimeter.(4) If continuity is not present, replacetransmission external wiring harness(para 6-7).(5) Connect negative (-) probe of multimeter toall other pins in connector P119 and notereading on multimeter.(6) Connect negative (-) probe of multimeter toground and note reading on multimeter.(7) If continuity is present, transmissionexternal wiring harness is shorted; replacetransmission external wiring harness(para 6-7).(8) Connect connector P119 to connectorJ119.(9) Position front grille on cab with washerand screw.(10) Position two washers and screws in frontgrille.(11) Tighten screw to 48-60 lb-in. (5-7 N·m).(12) Tighten two screws to 24 lb-in. (3 N·m).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
