Change 1 2-121
TM 9-2320-366-34-1
CAUTION
Use care when connecting wiring harness
connectors. Failure to comply may result in
damage to equipment.
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to output speed sensor connector pin A.
(3) Connect negative (-) probe of multimeter
to transfer case connector pin A and
note reading on multimeter.
(4) If continuity is not present, replace
transfer case wiring harness (para 8-2).
(5) Connect positive (+) probe of multimeter
to output speed sensor connector pin B.
(6) Connect negative (-) probe of multimeter
to transfer case connector pin B and
note reading on multimeter.
(7) If continuity is not present, replace
transfer case wiring harness (para 8-2).
(8) If continuity is present, replace WTEC II
TEPSS (TM 9-2320-366-20-4).
(9) Connect transfer case wiring harness
connector OSS to output speed sensor.
(10) Install gasket and valve body cover on
transfer case with ten screws.
(11) Connect transmission external wiring
harness transfer case connector to
transfer case connector.
(12) Add lubricating oil to transmission
(TM 9-2320-366-20).
(13) Connect batteries (TM 9-2320-366-20-3).
