Change 1 2-113
TM 9-2320-366-34-1
RESISTANCE TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to pin 1 of turbine speed sensor.
(3) Connect negative (-) probe of multimeter
to pin 2 of turbine speed sensor and note
reading on multimeter.
(4) If resistance is less than 200 ohms or
greater than 400 ohms, replace turbine
speed sensor (para 6-5).
(5) If resistance is between 200 and 400
ohms, replace WTEC II TEPSS
(TM 9-2320-366-20-4).
(6) Connect internal wiring connector TSS
to turbine speed sensor.
(7) Install cover on control valve module
with four screws.
(8) Install control valve module (para 7-10).
(9) Connect external wiring harness 24-pin
connector to internal wiring harness
24-pin connector.
(10) Tighten screw in external wiring harness
24-pin connector.
(11) Connect batteries (TM 9-2320-366-20-3).
