TM 9-2320-366-34-1 2-90          Change 1 INITIAL SETUP   Equipment Conditions     Engine shut down (TM 9-2320-366-10-1).     Batteries disconnected (TM 9-2320-366-20-3).   Tools and Special Tools     Tool Kit, Genl Mech (Item 78, Appendix B)     STE/ICE-R (Item 70, Appendix B)     Multimeter, Digital (Item 41, Appendix B)     Goggles, Industrial  (Item 28, Appendix B)     Wrench, Torque, 0-200 lb-in. (Item 93, Appendix B)     Wrench Set, Socket (Item 85, Appendix B) Materials/Parts   Wire, Elect, 50 ft (Item 97, Appendix C) Personnel Required   (2) References   TM 9-4910-571-12&P             KNOWN INFO              WARNING       CAUTION       Read WARNING and CAUTION on following page.            TEST OPTIONS            Continuity Test or STE/ICE-R Test #91     REASON FOR QUESTION     1. START        POSSIBLE PROBLEMS        Is continuity present from connector P119-p to external wiring harness 31-pin connector pin V? If continuity is not present, transmission external wiring harness is faulty. Circuit breaker OK. Batteries OK. WTEC II cab transmission harness OK. Faulty transmission external wiring harness. Faulty transmission adapter cable assembly. Faulty transmission internal wiring harness. Faulty transmission turbine speed sensor. Faulty WTEC II TEPSS. NO Replace transmission external wiring harness (para 6-7). YES c2. WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN         CODE 22 SUB  CODE 15 (PRIOR TO SERIAL NUMBER 6510032369 WITH TRANSMISSION       ADAPTER CABLE ASSEMBLY)