TM 9-2320-366-34-4
(40) Remove self-locking nut (9) from pinion drive shaft (8).
Discard self-locking nut.
CAUTION
Use care when removing pinion assembly.
Failure to comply may result in damage to
equipment.
(41) Remove pinion drive shaft (8) from differential carrier (1).
(42) Record pinion cone variation number at gear end of
pinion drive shaft (8).
(43) Remove three shims (57) and bearing cone (58) from
pinion drive shaft (8).
(44) Remove helical driven gear (20) and two spacers (59),
from differential carrier (1).
(45) Remove two bearing cones (60) and bearing cup (61)
from differential carrier (1).
(46) Remove self-locking nut (10) and input yoke (11) from
input bearing cage (16). Discard self-locking nut.
(46.1) Remove yoke seal (62) from input yoke (11). Discard
yoke seal.
(47) Remove input shaft (63) from input bearing cage (16).
(48) Remove bearing cone (64) from input shaft (63).
(49) Remove bearing cup (65) from input bearing cage (16).
(50) Remove oil seal (66) from input bearing cage (16).
Discard oil seal.
Change 1
24-7
