TM 9-2320-366-34-3
16-93. POWER TAKE-OFF (PTO) REPLACEMENT/REPAIR (CONT)
NOTE
Step (10) requires the aid of an assistant.
(10) Remove drive shaft (10) from frame (11).
(11) Position universal joint (12) on drive yoke (13) with two
bearing cups (14) and four screws (15).
(12) Tighten four screws (15) to 26-35 lb-ft (35-47 N·m).
NOTE
Perform steps (13) through (14.9) on vehicles
equipped with transmission oil cooler tubes.
Perform steps (13) and (14) on vehicles not
previously equipped with corrosive enhanced
fittings.
(13) Install preformed packing (16) on fitting (17).
(14) Install fitting (17) on transmission oil cooler (18).
(14.1) Install preformed packing (18.1) on fitting (17).
16-584
Change 1