TM 9-2320-366-34-3
(13) Position two springs (23), washers (24), and bolt (25) in
spooler weldment (17).
(14) Position plate (26) on spooler weldment (17) with six
bolts (27).
(15) Tighten bolts (27) to 76-84 lb-ft (103-114 N·m).
(16) Position two guide rollers (28), roller pins (29), retaining
plates (30), lockwashers (31), and bolts (32) on spooler
weldment (17).
(17) Tighten bolts (32) to 76-84 lb-ft (103-114 N·m).
(18) Tighten bolt (25) eight and one half turns.
NOTE
Left and right side gladhand brackets are
installed the same way. Left side shown.
(19) Position gladhand bracket (33) on spooler weldment (17)
with four washers (34), bolts (35), and self-locking nuts
(36).
(20) Tighten self-locking nuts (36) to 33-37 lb-ft (45-50 N·m).
(21) Perform steps (5) through (20) on right side of vehicle.
16-415