TM 9-2320-366-34-3
16-68. M1089 UNDERLIFT AND STIFFLEG ASSEMBLY REPLACEMENT (CONT)
NOTE
Left and right side tow chain anchors are
installed the same way. Left side shown.
(7) Position tow chain anchor (12) on fender (13) with four
washers (14) and bolts (15).
(8) Tighten bolts (15) to 152-168 lb-ft (206-228 N·m).
NOTE
Left and right side 30K winch cables are
installed the same way. Left side shown.
(9) Route 30K winch cable (16) through spooler weldment
(17).
(10) Install pin (18) in 30K winch cable (16) with cotter pin
(19).
(11) Position cable sheave (20) in spooler weldment (17).
WARNING
Use care when removing retaining rings.
Retaining rings are under tension and can
act as projectiles when released. Failure
to comply may result in injury to
personnel.
(12) Install pin (21) in spooler weldment (17) with two
retaining rings (22).
16-414