TM 9-2320-366-34-2
13-18. M1085 FRAME PLATE REPLACEMENT
This task covers:
a. LH Removal
b. LH Installation
c. RH Removal
d. RH Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Rear axle bogie shaft removed (para 10-4).
Rear torque rods removed (para 14-5).
Resilient mount and mechanical stops removed (TM 9-
2320-366-20-4).
15K Self-Recovery winch (SRW) cable pulleys removed,
if equipped (RH side) (TM 9-2320-366-20-5).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B)
Wrench Set, Socket (Item 84, Appendix B)
Wrench, Torque, 0-150 lb-in. (Item 91, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Socket Set, Socket Wrench (Item 59, Appendix B)
Wrench, Impact, Electric (Item 88, Appendix B)
Multiplier, Torque Wrench (Item 42, Appendix B)
Socket Set, Impact (Item 58, Appendix B)
Wrench Set, Socket (Item 85, Appendix B)
Materials/Parts (Cont)
Nut, Self-locking (2) (Item 173, Appendix F)
(RH side)
Nut, Self-locking (3) (Item 173, Appendix F)
(LH side)
Nut, Self-locking (8) (Item 212, Appendix F)
Bolt (20) (Item 2, Appendix F) (LH side)
Nut, Self-locking (20) (Item 204, Appendix F)
(LH side)
Bolt (19) (Item 2, Appendix F) (RH side with
winch)
Nut, Self-locking (19) (Item 204, Appendix F)
(RH side with winch)
Bolt (21) (Item 2, Appendix F) (RH side without
winch)
Nut, Self-locking (21) (Item 204, Appendix F)
(RH side without winch)
Bolt (10) (Item 7, Appendix F)
Nut, Self-locking (10) (Item 211, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. LH Removal.
(1) Remove three self-locking nuts (1), bolts (2), and clamps
(3) from frame plate (4). Discard self-locking nuts.
13-129
