TM 9-2320-366-34-2
NOTE
Perform steps (4) and (5) on vehicle serial
numbers 1399 through 2987.
(4) Position three washers (8), bolt (9), and self-locking nut
(10) in rear axle shock absorber (11).
(5) Tighten self-locking nut (10) to 195-239 lb-ft (264-324
N·m).
NOTE
Perform steps (6) and (7) on vehicle serial
numbers 0001 through 1398 and 2988 and
higher serial numbers.
(6) Position washer (12), bolt (9), and self-locking nut (10)
in rear axle shock absorber (11).
(7) Tighten self-locking nut (10) to 195-239 lb-ft (264-324
N·m).
(8) Position valve control panel (13) on structural support (1)
with two washers (14), bolts (15), washers (16), and self-
locking nuts (17).
(9) Tighten two self-locking nuts (17) to 14-18 lb-ft (20-24
N·m).
(10) Perform steps (9) and (10) on left side of structural
support.
e. Follow-On Maintenance.
(1) Install rear stabilizer brackets (M1090/M1094) (para 14-
10).
(2) Install rear crossmember (para 13-7).
End of Task.
13-77