TM 9-2320-366-34-2
d. M1093 Installation.
NOTE
Left and right side of rear tension beam is
installed the same way. Left side shown.
Steps (1) through (7) require the aid of an
assistant.
(1) Position rear tension beam (1) and taillight mounting
bracket (2) on vehicle with three bolts (3) and self-
locking nuts (4).
(2) Tighten three self-locking nuts (4) to 210-225 lb-ft (285-
305 N·m).
(3) Position rear spreader bar bracket (5) on rear tension
beam (1) with two bolts (6) and self-locking nuts (7).
(4) Tighten two self-locking nuts (7) to 210-225 lb-ft (285-
305 N·m).
(5) Position bolt (8) and self-locking nut (9) in rear tension
beam (1).
(6) Tighten self-locking nut (9) to 210-225 lb-ft (285-305
N·m).
(7) Install shackle (10) on rear tension beam (1) with pin
(11).
(8) Perform steps (1) through (7) on right side of rear
tension beam.
13-23