Do not use steel hammers to seat bearing
cups in drive yokes. Failure to comply may
result in injury to personnel or damage to
Check bearing cups to ensure all needle
bearings are in place to installation. Replace
bearing cups if needle bearings are missing or
out of place. failure to comply may result in
damage to equipment.
Wipe end of yoke bearing bores prior to
(7) Position universal joint (9) on drive yoke (10) with two
bearing cups (11) and four screws (12).
Alternately tighten screws.
When correct torque is reached, bearing cap
small screw hex head will break off.
(8) Tighten four screws (12).
Grease must flow from all four seals. Failure
to comply may result in damage to
(9) Apply lubrication to grease fittings (TM 9-2320-366-20).