TM 9-2320-366-34-2
9-2. FRONT AXLE ASSEMBLY REPLACEMENT (CONT)
(10) Position shock absorber (11) on front axle assembly (6)
with bolt (12), washer (13), and nut (14).
(11) Tighten nut (14) to 284-343 lb-ft (385-465 N·m).
(12) Perform steps (5) through (11) on left side of front axle
assembly.
NOTE
Step (12.1) requires the aid of an assistant.
(12.1) Remove drive shaft (14.1) from crossmember (14.2).
WARNING
Do not use steel hammers to seat bearing
cups in drive yokes. Failure to comply
may result in injury to personnel or
damage to equipment.
CAUTION
Check bearing cups to ensure all needle
bearings are in place to installation. Replace
bearing cups if needle bearings are missing or
out of place. Failure to comply may result in
damage to equipment.
NOTE
Wipe end of yoke bearing bores prior to
installation.
(13) Position universal joint (15) on drive yoke (16) with two
bearing cups (17) and four screws (18).
9-8
Change 1