8-4. M1086/M1089 INTERMEDIATE FRONT DRIVE SHAFT AND COUPLER BEARING
Do not use steel hammers to seat bearing
cups in drive yokes. Failure to comply
may result in injury to personnel or
damage to equipment.
Check bearing cups to ensure all needle
bearings are in place prior to installation.
Replace bearing cups if needle bearings are
missing or out of place. Failure to comply
may result in damage to equipment.
Wipe end of yoke bearing bores prior to
(10) Position universal joint (12) on intermediate front drive
yoke (13) with two bearing cups (14) and four screws
Alternately tighten screws.
When correct torque is reached, bearing cap
screw small hex head will break off.
(11) Tighten four screws (15).
Grease must flow from all four seals. Failure
comply may result in damage to
(12) Apply lubrication to grease fittings (1).
e. Follow-On Maintenance.
Test drive vehicle (TM 9-2320-366-10-1).
End of Task.