TM 9-2320-366-34-1
Change 1 2-838.1
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to transfer case connector pin B.
(3) Connect negative (-) probe of multimeter
to transfer case wiring harness connector
socket B and note reading on multimeter.
(4) If continuity is not present, replace
transfer case wiring harness (para 8-2).
(5) Connect positive (+) probe of multimeter
to transfer case connector pin B.
(6) Connect negative (-) probe of multimeter
to all other pins in transfer case connector
and note reading on multimeter.
(7) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(8) If continuity is present, transfer case
wiring harness is shorted; replace transfer
case wiring harness (para 8-2).
