• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN         CODE 41, 42, 44, 45 AND/OR 69 SUB CODE 23 (CONT) - TM-9-2320-366-34-1_547
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 41, 42, 44, AND/OR 45 SUB CODE 24 (SERIAL NUMBER 6510032369 AND        HIGHER)

TM-9-2320-366-34-1 M1078 Series 2 1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  475    476    477    478    479  480  481    482    483    484    485  
TM 9-2320-366-34-1 Change 1          2-421 RESISTANCE TEST CAUTION NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact.   (1)  Set multimeter to ohms.   (2)  Connect positive (+) probe of multimeter         to H solenoid connector pin A.   (3)  Connect negative (-) probe of multimeter         to H solenoid connector pin B and note         reading on multimeter.   (4)  If resistance is less than 2.5 ohms or         greater than 5.0 ohms, replace         H solenoid (para 8-2).   (5)  If resistance is between 2.5-5.0 ohms,         replace WTEC II TEPSS (TM 9-2320-366-         20-4).   (6)  Connect transfer case wiring harness         connector H to H solenoid connector.   (7)  Install valve body cover on transfer case         (para 8-2).   (8)  Connect external wiring harness transfer         case connector to transfer case wiring         harness external connector.   (9)  Connect batteries (TM 9-2320-366-20-3).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.