• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN         CODE 41, 42, 44, 45 AND/OR 69 SUB CODE 23 (CONT) - TM-9-2320-366-34-1_545
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN         CODE 41, 42, 44, 45 AND/OR 69 SUB CODE 23 (CONT) - TM-9-2320-366-34-1_547

TM-9-2320-366-34-1 M1078 Series 2 1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  473    474    475    476    477  478  479    480    481    482    483  
TM 9-2320-366-34-1 Change 1          2-419 CONTINUITY TEST CAUTION NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact.   (1)  Set multimeter to ohms.   (2)  Connect positive (+) probe of multimeter         to transfer case wiring harness external         connector pin B.   (3)  Connect negative (-) probe of multimeter to         transfer case wiring harness connector H         socket B and note reading on multimeter.   (4)  If continuity is not present, replace         transfer case wiring harness (para 8-2).   (5)  Connect positive (+) probe of multimeter         to transfer case wiring harness external         connector pin B.   (6)  Connect negative (-) probe of multimeter to         all other pins in transfer case wiring         harness external connector and note         reading on multimeter.   (7)  Connect negative (-) probe of multimeter to         ground and note reading on multimeter.   (8)  If continuity is present, transfer case         wiring harness is shorted replace transfer         case wiring harness (para 8-2).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.