TM 9-2320-366-34-1
Change 1 2-418.1
CONTINUITY TEST
CAUTION
NOTE
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
(1) Remove valve body cover (para 8-2).
(2) Disconnect transfer case wiring harness
connector H from H solenoid connector.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter
to transfer case wiring harness connector
pin A.
(5) Connect negative (-) probe of multimeter to
transfer case wiring harness external
connector H socket A and note reading on
multimeter.
(6) If continuity is not present, replace
transfer case wiring harness (para 8-2).
(7) Connect positive (+) probe of multimeter
to transfer case wiring harness external
connector pin A.
(8) Connect negative (-) probe of multimeter to
all other pins in transfer case wiring
harness external connector and note
reading on multimeter.
(9) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(10) If continuity is present, transfer case
wiring harness is shorted; replace transfer
case wiring harness (para 8-2).
