• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN          CODE 41, 42, 44, AND/OR 45 SUB CODE 16 (SERIAL NUMBER 6510032369            AND HIGHER) (CONT
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 41, 42, 44, AND/OR 45 SUB CODE 16 (PRIOR TO SERIAL NUMBER 6510032369        WITH TRANSMISSION ADAPTER CABLE ASSEMBLY)

TM-9-2320-366-34-1 M1078 Series 2 1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  373    374    375    376    377  378  379    380    381    382    383  
TM 9-2320-366-34-1 Change 1          2-321 RESISTANCE TEST CAUTION NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact. (1)  Set multimeter to ohms. (2)  Connect positive (+) probe of multimeter       to E solenoid connector pin A. (3)  Connect negative (-) probe of multimeter       to E solenoid connector pin B and note       reading on multimeter. (4)  If resistance is less than 2.5 ohms or       greater than 5.0 ohms, replace       E solenoid (para 7-7). (5)  If resistance is between 2.5-5.0 ohms,       replace WTEC II TEPSS (TM 9-2320-366-       20-4). (6)  Connect internal wiring harness connector E       to E solenoid connector. (7)  Install cover on control valve module with       four screws. (8)  Install control valve module (para 7-10). (9)  Connect batteries (TM 9-2320-366-20-3).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.