• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS           MAIN CODE 41, 42, 44, AND/OR 45 SUB CODE 15 (SERIAL NUMBER 6510032369           AND HIGHER) (CONT)
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS           MAIN CODE 41, 42, 44, AND/OR 45 SUB CODE 15 (SERIAL NUMBER 6510032369           AND HIGHER) (CONT)

TM-9-2320-366-34-1 M1078 Series 2 1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  337    338    339    340    341  342  343    344    345    346    347  
Change 1          2-285 TM 9-2320-366-34-1 CONTINUITY TEST Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact. CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. NOTE (1)  Set multimeter to ohms. (2)  Connect positive (+) probe of multimeter       to internal wiring harness 31-pin connector       pin A. (3)  Connect negative (-) probe of multimeter to       internal wiring harness connector D pin B       and note reading on multimeter. (4)  If continuity is not present, replace       transmission internal wiring harness       (para 7-13). (5)  Connect positive (+) probe of multimeter       to internal wiring harness 31-pin connector       pin A. (6)  Connect negative (-) probe of multimeter to       all other pins in internal wiring harness       31-pin connector and note reading on       multimeter. (7)  Connect negative (-) probe of multimeter to       ground and note reading on multimeter. (8)  If continuity is present, transmission       internal wiring harness is shorted; replace       transmission internal wiring harness       (para 7-13).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.