Change 1 2-203
TM 9-2320-366-34-1
CONTINUITY TEST
(11) Position two washers and screws in front
grille.
(12) Tighten screw to 48-60 lb-in. (5-7 N·m).
(13) Tighten two screws to 24 lb-in. (3 N·m).
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to connector P119-M.
(3) Connect negative (-) probe of multimeter
to external wiring harness 24-pin
connector pin A1 and note reading on
multimeter.
(4) If continuity is not present, replace
transmission external wiring harness
(para 6-7).
(5) Connect positive (+) probe of multimeter
to connector P119-M.
(6) Connect negative (-) probe of multimeter
to all other pins in connector P119 and
note reading on multimeter.
(7) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(8) If continuity is present, transmission
external wiring harness is shorted; replace
transmission external wiring harness
(para 6-7).
(9) Connect connector P119 to connector
J119.
(10) Position front grille on cab with washer
and screw.
