• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 32 AND ANY SUB CODE (PRIOR TO SERIAL NUMBER 6510032369)
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 32 AND ANY SUB CODE (PRIOR TO SERIAL NUMBER 6510032369) (CONT) - TM-9-2320-366-34-1_295

TM-9-2320-366-34-1 M1078 Series 2 1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  221    222    223    224    225  226  227    228    229    230    231  
Change 1          2-171 TM 9-2320-366-34-1 WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris.  Failure to comply may result in injury to personnel. CAUTION Loose or dirty connectors may cause intermittent loss of power to transmission ECU and diagnostic codes to be logged. Ensure that all connectors are clean and tight before performing troubleshooting.  Failure to comply may result in incorrect test results. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. NOTE CONTINUITY TEST Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact.   (1)  Remove two screws and washers from         front grille.   (2)  Remove screw and washer from front         grille.   (3)  Remove front grille from cab.   (4)  Disconnect connector P119 from         connector J119.   (5)  Loosen screw in external wiring harness         24-pin connector.   (6)  Disconnect external wiring harness 24-pin         connector from internal wiring harness         24-pin connector.   (7)  Set multimeter to ohms.   (8)  Connect positive (+) probe of multimeter         to connector P119-h.   (9)  Connect negative (-) probe of multimeter         to external wiring harness 24-pin         connector pin F2 and note reading on         multimeter. (10)  If continuity is not present, replace         transmission external wiring harness         (para 6-7). (11)  Connect positive (+) probe of multimeter         to connector P119-h. CONTINUITY TEST (Cont) (12)  Connect negative (-) probe of multimeter         to all other pins in connector P119 and         note reading on multimeter. (13)  Connect negative (-) probe of multimeter         to ground and note reading on multimeter. (14)  If continuity is present, transmission         external wiring harness is shorted; replace         transmission external wiring harness         (para 6-7). Ensure exhaust system is cool before performing troubleshooting. Failure to comply may result in injury to personnel.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.