TM 9-2320-366-34-1
D-23. SWINGDRIVE ASSEMBLY BRACKET
Make the swingdrive assembly bracket from the flat steel bar and flat washer according to the following instructions.
Refer to the parts list tables and accompanying figure for details.
Item
Material Description
Size
Qty
1
1/4 in. (0.64 cm) flat steel bar
1.25 in. (3.2 cm) x 2.50 in. (6.4 cm)
1
2
2 1/4 in. (5.7 cm) flat washer
2 1/4 in. OD (5.7 cm) x 1.25 in. ID (3.2)
1
Figure D-35 Swingdrive Assembly Bracket
a. All dimensions are in inches (centimeters).
b. Fabricate (1) from flat steel bar and flat washer (2) as identified in table.
c. Hold tolerances of dimensions given to two decimal places at 0.01 in. (0.02 cm).
d. Drill 0.50 in. (1.3 cm) diameter hole 2 places as shown in Figure D-35. Swingdrive Assembly Bracket.
e. Grind side of flat washer (2) and weld to flat bar (1) as shown in Figure D-35. Swingdrive Assembly Bracket.
f. Dimensions shown in Figure D-35. Swingdrive Assembly Bracket are for machining and positioning pieces.
g. De-burr and remove sharp edges.
D-40
